Cinecor Sub   Subwoofer as in K+T 1/2022

Technical data
  • impedance: 8 Ohm
  • sensivity (2,83V/1m): aktiv dB
  • size (HxWxD): 625 x 625 x 548 mm
  • frequency range (-8dB): 18 - 150 Hz
  • crossover frequency(s): aktiv Hz
  • speaker type: closed box
Enlarge

Cinecor Sub is a versatile subwoofer which complements the rest of the loudspeakers with a powerful and deep bass.

Cinecor Sub is a closed-cabinet loudspeaker with drivers of Celestion .

The kit is delivered with a Celestion NTR21-5010JD subwoofer

The loudspeaker has been developed by Thomas Schmidt and Michael Rochow.

The frequency response of this speaker is perfectly linear.

An excerpt from the Klang+Ton review (Translation of the author into English)

"Judging a subwoofer alone is always a little ungrateful. Rule of thumb: If it is no longer noticeable, it is correctly adjusted. With our Cinecor L box, I had to tinker with it for a long time before the transition fit, because even if the box has a gently roll-off towards the bass, it reaches tremendously deep in the listening room, so that in the end I had to close the reflex tubes to get a clean transition at all. But what then happened dynamically was already an event: music and film material were presented on such a high dynamic level that I couldn't think of anything at first - and believe me: I always find some criticism ... But this is, apart from the infinite power reserves, also in terms of musicality, spatial imaging and yes, also in terms of fine dynamics and attention to detail, a real challenge to the very expensive high-end ready-made speakers. I'm really looking forward to the finished surround set!"

Conclusion of the magazine Klang+Ton:

"Highly dynamic subwoofer that leaves nothing to be desired."

Our kit without amplifier consists of

  • Celestion NTR21-5010JD
  • 0,5x PE sealing tape, 5x2 mm, 7.5 m
  • 0,5x Foam N25-30, 100 x 50 cm, black
  • Binding Post PK28 I, gold plated (one pair, red and black)
  • 1m Speaker cable 2x2.5 mm2, transparent
  • 8x 1 pieces drive-in nuts M6, DIN 6930 g zinc-plated
  • 8x 1 pieces Allen screws M6x50, DIN 912, black
  • Plan for DIY kit

Kit without cabinet and without amplifier, price per speaker   - not available

Price for a pair of custom speakers of any color   - not available (_)

Kit with amplifier

  • Celestion NTR21-5010JD
  • Hypex FusionAmp FA502
  • 0,5x PE sealing tape, 5x2 mm, 7.5 m
  • 0,5x Foam N25-30, 100 x 50 cm, black
  • 8x 1 pieces drive-in nuts M6, DIN 6930 g zinc-plated
  • 8x 1 pieces Allen screws M6x50, DIN 912, black
  • 1,5x Pan screws 4x20 black, torx, 8 pieces
  • Plan for DIY kit

Kit without cabinet, price per speaker   - not available


Home   Klang+Ton Overview